4 Table of Contents Showing the sketches 2-8 Creating a coincident plane 2-9 Creating a parallel plane 2-10 Creating the recess 2-11 Creating an offset-distance plane 2-12 Creating the bore holes 2-12 Creating a perpendicular plane 2-13 Creating the side-grips 2-14 Creating a circular pattern of the grips 2-15 Creating a Mid-Plane 2-17 Adding fillets to all edges 2-19 Questions for Review 2-20 Exercise: Creating new planes 2-22 Chapter 3: Advanced Modeling 3-1 5/8 Spanner 3-2 Tools needed 3-2 Opening the spanner sketch document 3-3 Arc conditions 3-3 Creating the transition sketch 3-4 Creating a new work plane 3-6 Creating the closed-end sketch 3-7 Extruding the closed-end feature 3-7 Adding a 12-sided polygon hole 3-8 Creating the recess profile 3-9 Mirroring the recessed feature 3-10 Adding fillets 3-11 Adding text 3-13 Extruding the text 3-14 Questions for Review 3-17 Exercise: Circular text wraps 3-19 Chapter 4: Sweep with Composite Curves 4-1 Helical Extension Spring 4-2 Tools needed 4-2 Sketching the first profile 4-3 Converting the circle into a helix 4-3 Creating a 2-degree plane 4-4 Sketching the large loop 4-5 Sketching the large hook 4-5 Creating a parallel plane 4-6 IXĥ Creating a Composite Curve 4-8 Sweeping the profile along the path 4-11 Other spring examples 4-12 Questions for review 4-13 Exercise: Circular Spring 180 deg Using Variable Pitch 4-17 Multi-Pitch Spring with Closed Ends 4-18 Tools Needed 4-18 Creating the base sketch 4-19 Creating a helix with variable pitch 4-19 Sweeping the profile along the path 4-21 Creating a trimmed sketch 4-22 Extruding a cut 4-22 Questions for Review 4-23 Exercise: Projected Curve & Composite Curve 4-24 Chapter 5: Advanced Modeling with Sweep & Loft 5-1 Water Pump Housing 5-2 Tools Needed 5-2 Understanding the draft options 5-3 Opening a part document 5-4 Sketching the upper inlet port 5-5 Adding fillets 5-6 Creating offset-distance planes 5-7 Creating a loft feature 5-10 Creating the mounting bosses 5-11 Sketching the rear inlet port 5-12 Revolving the rear inlet port 5-12 Adding face Fillets 5-13 Mirroring the rear inlet port 5-15 Shelling the part 5-16 Adding a rib 5-17 Mirroring the rib 5-18 Adding fillets 5-19 Chapter 6: Loft vs.

Advanced solidworks pdf